[Nut-upsuser] newhidups/APC: load always 0?

[Peter Selinger]

Don't know. You could run the driver with -DD to see the raw data
reported by the UPS. -- Peter

Tom Laermans wrote:
> 
> 'lo,
> 
> UPS model: APC Back-UPS BR 800 (supplied by Dell)
> 
> My USB connection:
> 
> Bus 001 Device 002: ID 051d:0002 American Power Conversion Back-UPS Pro
> 500/1000/1500
> 
> # upsc desk at localhost|grep load
> ups.load: 0.0
> 
> This UPS has 2 pc's and some minor other gear connected, yet the load
> stays at 0.0 when checking with nut.
> 
> driver.version: 2.0.5
> driver.version.data: APC/CyberPower HID 0.9
> driver.version.internal: 0.30
> 
> ups.conf:
> [desk]
>         driver = newhidups
>         port = auto
>         desc = "Desk UPS"
> 
> I have not tried Windows with PowerChute yet to see if it is reported
> corretly there; other values in the UPS data seem to be correct and
> valid.
> 
> Any clues? bug in NUT? bug in UPS?
> 
> Thanks,
> -- 
> Tom Laermans
> System Administrator
> 
> Luciad NV - http://www.luciad.com
> Gaston Geenslaan 9, 3001 Leuven, Belgium
> 
> 
> 
> 
> _______________________________________________
> Nut-upsuser mailing list
> Nut-upsuser at lists.alioth.debian.org
> http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
>