[Nut-upsuser] Mustek PowerMust 600 USB configuration

[Janeks Kamerovskis]

Hi!

I am trying to install subj, on my Bubba miniserver, that runs Debian.

I am stoped now with driver test:

upsdrvctl start
Network UPS Tools - UPS driver controller 2.0.4
Network UPS Tools - Megatec protocol driver 1.4 (2.0.4)
Carlos Rodrigues (c) 2003-2006


Unable to open : No such file or directory

Things to try:

 - Check 'port=' in ups.conf

 - Check owner/permissions of all parts of path

Fatal error: unusable configuration
Driver failed to start (exit status=1)


I successfully installed NUT by using apt-get, configured config files.

In my ups.conf I have:

[mustekUPS]
	driver = megatec
        port= /dev/usb/hiddev0

Bubba miniserver has only USB ports outside.

dmesg gives (I just posted part of output, that I felt significant):

Linux version 2.6.26.5 (tor at sid) (gcc version 4.1.1) #1 Tue Sep 16
18:11:30 CEST 2008
Found legacy serial port 0 for /soc8313 at e0000000/serial at 4500
  mem=e0004500, taddr=e0004500, irq=0, clk=133333334, speed=0
Found legacy serial port 1 for /soc8313 at e0000000/serial at 4600
  mem=e0004600, taddr=e0004600, irq=0, clk=133333334, speed=0
console [udbg0] enabled
Entering add_active_range(0, 0, 65536) 0 entries of 256 used
Found MPC83xx PCI host bridge at 0x00000000e0008500. Firmware bus
number: 0->0
PCI host bridge /soc8313 at e0000000/pci at 8500 (primary) ranges:
...
usb 1-1.2: new low speed USB device using fsl-ehci and address 7
usb 1-1.2: configuration #1 chosen from 1 choice
usbcore: registered new interface driver hiddev
hiddev96: USB HID v1.00 Device [Cypress Semiconductor USB to Serial] on
usb-fsl-ehci.0-1.2
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver

What could be done to get them working?

I read from some lists that there is megatec_usb driver and that had
worked with UPS in the subj. But I haven't it in my installation.
I tried also drivers: mustek and powermust, but without success.

brgds and looking forward for your reply,
Janeks