[Nut-upsuser] (no subject)

[ahouse-support]

I am have a nice result whith blazer_ser driver! respect!

# ./nut start
Network UPS Tools - UPS driver controller 2.4.1
Network UPS Tools - Megatec/Q1 protocol serial driver 1.51 (2.4.1)
Supported UPS detected with megatec protocol
Vendor information read in 1 tries
Battery runtime will not be calculated (runtimecal not set) 
<================= !!!
Starting nut.
Network UPS Tools upsd 2.4.1
listening on 172.16.0.220 port 3493
listening on 127.0.0.1 port 3493
Connected to UPS [Powercom]: blazer_ser-Powercom

backup# upsc Powercom at localhost
battery.voltage: 28.80 <========= !!! it is a normal? what u thing about 
this value??  iam have 4x7AH battery in Ups
battery.voltage.nominal: 24.0
beeper.status: disabled
driver.name: blazer_ser
driver.parameter.pollinterval: 2
driver.parameter.port: /dev/cuau0
driver.version: 2.4.1
driver.version.internal: 1.51
input.current.nominal: 5.0
input.frequency: 50.0
input.frequency.nominal: 50
input.voltage: 237.0
input.voltage.fault: 237.0
input.voltage.nominal: 220
output.voltage: 237.0
ups.delay.shutdown: 30
ups.delay.start: 180
ups.firmware: LCD  V2.1
ups.load: 74
ups.mfg: POWERCOM
ups.model: RXL-1000
ups.status: OL
ups.temperature: 0.0
ups.type: online

Broadcast Message from *******************
        (no tty) at 22:42 EET...

Communications with UPS Powercom at localhost established

im come back after learning you Tools!! thx!