[Nut-upsuser] Support for Online Yunto and Zinto

[Mario Giammarco]

Tomorrow I will do the test!

2012/2/16 Arnaud Quette <aquette.dev at gmail.com>:
> Halo Thomas und Mario ;-)
>
> 2012/2/14 Thomas Maisl <exp-122008 at maisl.com>:
>>
>> attached information was retrieved while UPS was operating _offline_ (doing
>> a runtime test)
>
> thanks a lot for your test results.
>
>> 1. lsusb -v -d06dA:0002
>> 2-6. blazer_usb using subdriver <cypress|phoenix|ippon|krauler>
>>     with and w/o protocol zinto
>>
>> IMO cypress with zinto produced the best result, ippon and krauler didn't work
>
> indeed cypress with zinto is the best fit, though your unit doesn't
> answer to anything else than the basic 'Q1'
> phoenix also provides the same support.
>
>>  [YQ450]
>>        driver = blazer_usb
>>        subdriver = cypress
>>        protocol = zinto
>>        vendorid = 06da
>>        productid = 0002
>>        port = auto
>>        desc = "Yunto YQ450 via USB"
>
> I've just committed a patch to the trunk (r3447) which links
> "06da:0002" to the cypress subdriver, and added the following HCL
> entry:
>
> "Online"        "ups"   "2"     "Yunto YQ450"   ""      "blazer_usb"
>
> This means that you now (using the latest trunk) just need to specify:
> [YQ450]
>      driver = blazer_usb
>      protocol = zinto
>      port = auto
>      desc = "Yunto YQ450 via USB"
>
> Moreover, specifying "zinto" is not that useful, since only "Q1" is supported.
> So you can omit it.
>
> Can you please counter check, and report back upsc/upsrw/upscmd
> output, along with the shutdown test:
> http://www.networkupstools.org/docs/user-manual.chunked/ar01s06.html#Shutdown_design
>
> the remaining point is still with the other unit (06da:0601) from Mario...
> @Mario: as  per your previous feedback, your unit reports 'Q1', 'F',
> but not 'I'.
> so could you please do the same tests I asked Thomas, with "protocol=zinto"?
> this should use 'FW?' and provide vendor info.
>
> cheers,
> Arnaud