[Nut-upsuser] APC Smart-UPS C1500 connected by usb

[Selva Nair]

Hi,

I have setup NUT in netserver mode on debian wheezy with two APC UPS units
connected to it by usb. lsusb identifies the units as Smart-UPS 1000 and
Smart-UPS C1500. It appears these do not use the smart protocol and
usbhid-ups is the correct driver to use.

System: Debian wheezy with stock version of nut
  (Version: 2.6.4-2.3+deb7u1)

Everything works rather well, except that the cgi-interface does not report
input/output voltages and load for the C 1500 unit.
upsc also reports these values only for model  1000, not for 1500. Battery
charge is and runtime are reported.

Is this a limitation of the driver, or is there way to get these data?

Thanks

Selva
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.alioth.debian.org/pipermail/nut-upsuser/attachments/20141108/d0c7e757/attachment.html>