[Nut-upsuser] NUT Client shuts down when performing runtime calibration on APC UPS

Charles Lepple clepple at gmail.com
Fri Dec 23 23:32:57 UTC 2016


On Dec 20, 2016, at 9:03 AM, Merk - Oliver <oliver.merk at pecon.biz> wrote:
> 
> Hello,
> 
> Last week I need to change the battery pack and then I needed to perform a runtime calibration. I used the web interface of the AP9630 card to start the runtime calibration. However, after 2min. of runtime calibration the SAN shut down!

It occurs to me that you may not have seen Roger's response, since it does not look like you were subscribed at that point. 

http://lists.alioth.debian.org/pipermail/nut-upsuser/2016-December/010480.html

Subscription information is below. This is a low-traffic list, as you can see from the archives. 
> _
> Nut-upsuser mailing list
> Nut-upsuser at lists.alioth.debian.org
> http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/nut-upsuser
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.alioth.debian.org/pipermail/nut-upsuser/attachments/20161223/90f29042/attachment.html>


More information about the Nut-upsuser mailing list