Bug#386052: zaptel-source: Cannot initiate a call to BRI

[Jens Wilke]

On Wednesday 06 September 2006 21:18, Cybaer wrote:
> Most of the time (the above I managed only once) I get the following
> effect after reloading the module and starting up asterisk in console mode:
>
>  [chan_zap.so] => (Zapata Telephony w/PRI)
>   == Parsing '/etc/asterisk/zapata.conf': Found
> Sep  6 21:07:44 WARNING[5108]: chan_zap.c:1097 zt_open: Unable to
> specify channel 1: No such device or address
> Sep  6 21:07:44 ERROR[5108]: chan_zap.c:7359 mkintf: Unable to open
> channel 1: No such device or address
> here = 0, tmp->channel = 1, channel = 1
> Sep  6 21:07:44 ERROR[5108]: chan_zap.c:12169 setup_zap: Unable to
> register channel '1-2'
> Sep  6 21:07:44 WARNING[5108]: loader.c:414 __load_resource:
> chan_zap.so: load_module failed, returning -1
> Sep  6 21:07:44 WARNING[5108]: loader.c:554 load_modules: Loading module
> chan_zap.so failed!
> mymachineprompt:~# Junk at the beginning 49443303
> Warning, flexibel rate not heavily tested!
> Junk at the beginning 49443303
> Warning, flexibel rate not heavily tested!
> Junk at the beginning 49443303
> Warning, flexibel rate not heavily tested!
> Junk at the beginning 49443303
> Warning, flexibel rate not heavily tested!

For that case I would like to see the output of:
 ztcfg -vv
dmesg