[sane-devel] HP4c & Buslogic BT-958

[Steven Lembark]

> Having just read it again myself, from the rpm, sane-backends-1.0.5-4
>
>  BusLogic BT958
>                      To configure the BusLogic card, you may need
>                      to follow these instructions (contributed by
>                      Jeremy <jeremy at xxedgexx.com>): During  boot,
>                      when your BusLogic adapter is being initial­
>                      ized, press Ctrl-B to  enter  your  BusLogic
>                      adapter  setup.   Choose  the  address which
>                      your BusLogic  containing  your  scanner  is
>                      located.  Choose  ``SCSI  Device  Configura­
>                      tion''.  Choose ``Scan SCSI  Bus''.   Choose
>                      whatever  SCSI id that contains your scanner
>                      and then choose ``View/Modify SCSI  configu­
>                      ration''.     Change    ``Negotiation''   to
>                      ``async''  and  change   ``Disconnect''   to
>                      ``off''.  Press  Esc,  save,  and  Esc again
>                      until you are asked to reboot.

Double checked the BT-948 config, re-ran scanimage -L w/
debugging turned on. Still no luck (see attached). The
sane-find-scanner quickly identifies the device as my
scanner; it's scanimage that keeps blowing up.

--
Steven Lembark                               2930 W. Palmer
Workhorse Computing                       Chicago, IL 60647
                                            +1 800 762 1582
-------------- next part --------------
A non-text attachment was scrubbed...
Name: a
Type: application/octet-stream
Size: 8260 bytes
Desc: not available
URL: <http://alioth-lists.debian.net/pipermail/sane-devel/attachments/20011124/5b5c0ce9/attachment.obj>