[sane-devel] HP4c & Buslogic BT-958

[Marcel Pol]

On Sat, 24 Nov 2001 01:01:10 -0600
Steven Lembark <lembark at wrkhors.com> wrote:

> > Having just read it again myself, from the rpm,
sane-backends-1.0.5-4
> >
> >  BusLogic BT958
> >                      To configure the BusLogic card, you may need
> >                      to follow these instructions (contributed by
> >                      Jeremy <jeremy at xxedgexx.com>): During  boot,
> >                      when your BusLogic adapter is being initial­
> >                      ized, press Ctrl-B to  enter  your  BusLogic
> >                      adapter  setup.   Choose  the  address which
> >                      your BusLogic  containing  your  scanner  is
> >                      located.  Choose  ``SCSI  Device  Configura­
> >                      tion''.  Choose ``Scan SCSI  Bus''.   Choose
> >                      whatever  SCSI id that contains your scanner
> >                      and then choose ``View/Modify SCSI  configu­
> >                      ration''.     Change    ``Negotiation''   to
> >                      ``async''  and  change   ``Disconnect''   to
> >                      ``off''.  Press  Esc,  save,  and  Esc again
> >                      until you are asked to reboot.
> 
> Double checked the BT-948 config, re-ran scanimage -L w/
> debugging turned on. Still no luck (see attached). The
> sane-find-scanner quickly identifies the device as my
> scanner; it's scanimage that keeps blowing up.

You did try it also with disconnect set to default, instead to off?

--
Marcel Pol
mpol at gmx.net

Linux 2.4.13-8mdksmp, up 6 days 7:23