[sane-devel] Help With HP ScanJet 3C - Getting Started

[Peter Kirchgessner]

Hi Chris,

did you have a look at http://www.kirchgessner.net/sanehpfaq.html ? 
There are some hints for use of HP-scanners.
Unfortunately your Symbios Logic SCSI card seems to be not easy to 
operate. You can browse through the sane-devel mailing list for 
additional hints. But several people gave up using this card.

--Peter

Chris Montgomery wrote:

> Sorry to ask a newbie question, but I need some help getting my scanner
> going under Red Hat 7.1.
> 
> I have sane 0.82 and xsane 1.0.3 installed.

> I did not config my kernel for
> the scanner at the time of install, but I would like to do that now. When
> I try to start xsane, I get the error "xsane: no devices available." 
> 
> I've been all over the Sane web site, read How-to's on
> hardware/scsi/kernel, etc., and ended up with a major headache. I guess I
> need help with just the basics, configuring my system to use a SCSI
> scanner device. The SCSI card is a Symbios Logic SCSI interface card (chip
> set Sym53C400A, card # C2502) for my ScanJet 3C.
> 
> As you can probably tell, I'm new to Linux. Any help would be greatly
> appreciated.
> 
> TIA,
> 
> Chris
> _______________________________________________
> Sane-devel mailing list
> Sane-devel@www.mostang.com
> http://www.mostang.com/mailman/listinfo/sane-devel
> 
> 


-- 
Peter Kirchgessner
http://www.kirchgessner.net
mailto:peter@kirchgessner.net