[sane-devel] Xsane go.... -no go.... "Bugger!"

Frank Frank at snapafun.co.nz
Sun Aug 3 07:20:20 BST 2003


Having followed the mailing list here to gain insight and knowledge to help me 
get my scanner sailing, [ Both within Mandrake 9.0 and now 9.1 ], I now find 
I need to seek your help with my Acer (Benq) 640U scanner and hope that this 
is the place for my particular problem.

I have installed Mandrake9.1 three times so far [ Partitioning experiments ] 
and each time my scanner is [ and still is ] recognized.

Then I went and replaced my second USB2 connected camera with a USB2 hub. I 
noticed almost immediately that Linux-Mandrake did not prefer to have the 
"Self" power enabled and worked better without that feature running. I did 
not change the (First) USB2 connector and left the scanner connected to it 
directly.

However I now have two problems.

1. The scanner light stays on all the time, even after a "Halt" and 

2. Xsane [and other programs, eg. OOo1.1rc] can no longer access the 
scanner.....

"Failed to open device 'snapscan:/dev/usb/scanner0'. Invalid argument."

Yes, things worked great before, even surviving my many re-installs.

As above, I hope this is the right place and regardless, any suggestions are 
welcome. (Be as childlike as you care to, I do not mind, everything helps me 
learn.)

Regards
-- 
Frank

Big or small, any challenge requires the same commitment to resolve.





More information about the sane-devel mailing list