[sane-devel] Re: [ANN] Plustek Backend update V0.45-1
Sun, 12 Jan 2003 13:21:01 -0500
On Sunday 12 January 2003 09:13, Jaeger, Gerhard wrote:
>On Saturday, 11. January 2003 22:08, Gene Heskett wrote:
>> On Saturday 11 January 2003 10:05, Jaeger, Gerhard wrote:
>> Announcing a 45-1 release.
>> I unpacked it over the old 45 in sane-backends-1.0.9, did a make
>> clean && make && make install, which apparently went well.
>> Fireing up xsane from the icon, I had it do a preview, which ran
>> as far as the end of the forward travel of the carriage, at
>> which time it cleared Olivers logo from the preview window, and
>> the whole thing went away about 1 second later. The carriage
>> went back home as it should have, but the lamp was left on.
>Quite a strange behaviour! I recommend to check the .conf file
> each time you make an update.
>> Running it from a shell, it did the same thing, and reported a
>> "segfault" to the shell window as it exited.
>I remember this behaviour a long time ago, but after a complete
>source code review and cleanup of my environment there are no
>problems left here!
>> The epson iscan-1.40 derived backend still works ok though.
>It should do so;-)
>> I'm going to do another make clean and get rid of the
>> config.cache etc stuffs and try it again, as I've re-arranged
>> the order in ld.so.conf a bit since that configure was done.
>> Humm, that might have done something, in 2 restarts it hasn't
>> crashed yet.
[snip the rest of my whining]
Got the email with the debug enabled file, and you should have the
debug history by now.
AMD K6-III@500mhz 320M
99.22% setiathome rank, not too shabby for a WV hillbilly