[sane-devel] configuring devicename so it can be used in gimp

[Praveen Kallakuri]

Hello,

I am relatively new to sane and after digging around for a few hours now, I
still cannot find the solution to what seems to be a simple problem.

I can get xsane to start up and connect to my scanner using the following
command:

xsane hpaio:/net/Officejet_6300_series?ip=192.168.15.102
>

But without the devicename, i get the "no devices avaliable" error. I can
live with this if I used xsane standalone, but I want to use it from gimp.

>From the xsane man page:

When xsane is started from the gimp then it is not possible  to  add  a
> devicename explicitly. You have to make the devices known to the system by
> configuring sane-dll, sane-net and saned.
>

Problem is that I don't know what else to do in terms of sane-dll
configuration except that I have ensured that there is an
/etc/sane.d/dll.d/hplip and that file has the "hpaio" backend in it (I am
running ubuntu dapper). I also tried specifying the backend directly in
dll.conf and also adding  "hpaio:/net/Officejet_6300_series?ip=
192.168.15.102" but to no avail.

sane-net and and saned don't seem to be relevant to my situation since it
seems to enable controlling "devices attached to a remote host". saned seems
to do the opposite and that seems irrelevant too.

Any help?

-- 

                                                       k.p.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.alioth.debian.org/pipermail/sane-devel/attachments/20060606/c068e399/attachment.htm