[sane-devel] Fw: Re: Can't seem to find config files
Jack McGill
jmcgill85258 at yahoo.com
Wed Nov 5 14:36:10 UTC 2008
Jack McGill
--- On Wed, 11/5/08, Jack McGill <jmcgill85258 at yahoo.com> wrote:
> From: Jack McGill <jmcgill85258 at yahoo.com>
> Subject: Re: [sane-devel] Can't seem to find config files
> To: "Igor G Novikov" <septagramm at gmail.com>
> Date: Wednesday, November 5, 2008, 6:20 AM
> --- On Wed, 11/5/08, Igor G Novikov
> <septagramm at gmail.com> wrote:
>
> > From: Igor G Novikov <septagramm at gmail.com>
> > Subject: Re: [sane-devel] Can't seem to find
> config files
> > To: sane-devel at lists.alioth.debian.org
> > Date: Wednesday, November 5, 2008, 3:35 AM
> > Thanks to both Jack and Olaf for advice.
> >
> > Now all configuration files are in place, except one,
> sadly
> > being
> > mustek_usb2.conf... Which is just like it was when
> sane was
> > installed
> > from an rpm package. That's strange, because
> > ./configure clearly says
> > that backend will be built:
> >
> I'm just guessing here, but the mustek_usb2 backend
> probably doesn't need a .conf file because it only
> supports one scanner at the present time. You could try the
> change the product id in the source code to your scanner, in
> the file that I mentioned previously and rebuild sane, and I
> bet that your scanner will then be recognized by scanimage
> -L.
>
> Also, read this
> http://www.sane-project.org/man/sane-mustek_usb2.5.html
> http://www.meier-geinitz.de/sane/mustek_usb2-backend/
> and
> http://www.meier-geinitz.de/sane/gt68xx-backend/adding.html
> the last reference describes how to add a device to a
> different backend, so the details will be different, but
> some of the principles will be the same.
> >
> > Also sane-find-scanner and scanimage -L still
> don't
> > identify my scanner
> > (i did change sources as Jack suggested). However,
> > sane-find-scanner
> > output changed slightly from when i was running it
> from rpm
> > package. It
> > now only says my scanner is Hewlett Packard when run
> as
> > root, otherwise
> > it doesn't say anything except vendor, product and
> chip
> > id:
> >
> > found USB scanner (vendor=0x055f, product=0x0408,
> > chip=SQ113?) at
> > libusb:001:004
> > --instead of--
> > found USB scanner (vendor=0x055f [Hewlett-Packard.
>
> > ],
> > product=0x0408 [USB2.0 Scanner ],
> chip=SQ113) at
> > libusb:001:004
> >
> > So i suppose support for BearPaw, even though actually
> > present in
> > sources, should be somehow enabled? How can it be
> done?
> >
> > P.S. It's maybe offtopic, but i feel very curious.
> > Jack, you are
> > precisely right about my cdma modem, where did you
> look it
> > up?
>
> I googled the product ID and vendor ID.
>
> Good luck and keep us updated.
>
> Jack
More information about the sane-devel
mailing list