[sane-devel] Help with canon FS2710 on Mac OSX Tiger/G4
Kirk Becnel
kirkbecnel at yahoo.com
Thu May 6 15:54:17 UTC 2010
I cannot get sane to work, except once, then when I used image capture, it stopped working and did not work again.
It is found
john-does-power-mac-g4:/usr/local/bin becnel$ ./sane-find-scanner -q
found SCSI scanner "CANON IX-27025E 1.13" at <01851f000000001736ab60d8>
But when I run scanimage:
john-does-power-mac-g4:/usr/local/bin becnel$ ./scanimage -T
scanimage: no SANE devices found
Here is my config for it:
john-does-power-mac-g4:/usr/local/etc/sane.d becnel$ cat canon.conf
#canon.conf
scsi CANON * Scanner
#/dev/sg0
john-does-power-mac-g4:/usr/local/bin becnel$ ./scanimage -L
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
john-does-power-mac-g4:/usr/local/bin becnel$ ./scanimage -v
scanimage: no SANE devices found
john-does-power-mac-g4:/usr/local/bin becnel$
I was able to get scans to work with vuescan and silverfast, but for what I am doing would rather use sane.
More information about the sane-devel
mailing list