[sane-devel] [PATCH 2/2] Man page spelling fixes.
ville.skytta at iki.fi
Sun Dec 15 12:04:43 UTC 2013
doc/sane-cardscan.man | 2 +-
doc/sane-genesys.man | 2 +-
doc/sane-pixma.man | 2 +-
doc/sane-umax_pp.man | 4 ++--
4 files changed, 5 insertions(+), 5 deletions(-)
diff --git a/doc/sane-cardscan.man b/doc/sane-cardscan.man
index 75cd161..7c081af 100644
@@ -53,7 +53,7 @@ used by the backend:
"lines_per_block 16" (or other number from 1 to 32)
-Controls the number of lines of image data which will be aquired in each pass.
+Controls the number of lines of image data which will be acquired in each pass.
Older scanners will require this number set lower, often 1.
diff --git a/doc/sane-genesys.man b/doc/sane-genesys.man
index 0cd1ffb..f352f32 100644
@@ -64,7 +64,7 @@ will have to be redone.
.B \-\-threshold percent
0..100% (in steps of 1). Select minimum brightness to get a white point. Pixels
-whith brightness below that value will be scanned as black.
+with brightness below that value will be scanned as black.
.B \-\-brightness value
diff --git a/doc/sane-pixma.man b/doc/sane-pixma.man
index 60184d0..d9e82ee 100644
@@ -122,7 +122,7 @@ where x, y and z are vendor ID, product ID and serial number respectively.
Example: pixma:04A91709_123456 is a MP150.
Device names for BJNP devices is in the form pixma:aaaa_bbbbb
-where aaaa is the scanners model and bbbb is the hostname or ip-adress.
+where aaaa is the scanners model and bbbb is the hostname or ip-address.
This backend, based on cloning original Canon drivers protocols, is in
a production stage. Designed has been carried out without any applicable
diff --git a/doc/sane-umax_pp.man b/doc/sane-umax_pp.man
index 2a8349d..09e6ea0 100644
@@ -58,7 +58,7 @@ needs to run as root. To allow user access to the scanner
run the backend through the network interface (See saned(8) and sane\-net(5)).
A more relaxed solution (security wise) is to add suid bit to the frontend
-The backend drop root priviledges as soon as it can, right after gaining direct
+The backend drop root privileges as soon as it can, right after gaining direct
access to IO ports, which lessen risks when being root.
.SH "DEVICE NAMES"
@@ -100,7 +100,7 @@ root (*BSD and linux), or with 'IOPL=yes' on
-\fBNOTE:\fR in all cases, you must have sufficient priviledges
+\fBNOTE:\fR in all cases, you must have sufficient privileges
to get access to the chosen device or address. Depending on the
security settings, devices may not be available for all users.
You have to change permissions on the dev/ppi* or /dev/parport* devices.
More information about the sane-devel