[sane-devel] Canon MX 725 network problems

HelpHelp helphelp at ecohilfe.de
Wed Aug 20 19:17:20 UTC 2014

Hello Luis,

I am not scanning from the ADF.  I am using the flatbed scanner.
What I have seen so far is:

1.) I can scan more that 3 times, as long as I scan quickly.
2.) When I scan, and then for example, change some settings (like output 
format, etc,) and wait a little bit,  I get a error message and the 
scanner is not responding anymore. I have to quit the program (I was 
using xsane) and start it again. Bit this happens in all other programs 
like gscan2pdf, simplescan, etc. to.


On 20.08.2014 00:02, Louis Lagendijk wrote:
> On Tue, 2014-08-19 at 20:57 +0200, HelpHelp wrote:
>> Hi Lois,
>> i needed a while for getting the error message.
>> Therefore the log is pretty big. You will find the error on the end.
>> Link: https://dl.dropboxusercontent.com/u/12003240/sane.log.7z
> Were you scanning from the ADF here? I see  a sequence that seems to
> suggest a completed page scan and a new page started. Is that correct?
> If so I may have to re-open a TCP connection for that to be
> possible.....
> Kind regards, Louis

More information about the sane-devel mailing list