[sane-devel] Scanner failure when connected via USB3

[Olaf Meeuwissen]

Mike Cloaked writes:

> Secondly i set up wireshark this afternoon, and got it all running to
> capture usb data on the bus that the scanner is connected to.  Having
> completed a capture for a vuescan run scanning the same docuument as
> previously. I then reset the scanner, and wireshark, and ran a scan in
> xsane - but instead of hanging it worked!  The only change since the
> previous time I booted the same laptop is that I ran a system update - but
> there was no obvious package that was updated that would have contributed
> to the changed behaviour!

Not obvious to you perhaps but maybe someone else?  Would you happen to
have the full list of packages (as well as their old and new versions)?
Maybe someone will spot something.

BTW, did you boot with the same kernel?

Hope this helps,
-- 
Olaf Meeuwissen, LPIC-2           FLOSS Engineer -- AVASYS CORPORATION
FSF Associate Member #1962               Help support software freedom
                 http://www.fsf.org/jf?referrer=1962