[sane-devel] Canon DR-7080C
wideboy3 at gmail.com
Wed Sep 24 16:45:51 UTC 2014
the out put from scanimage -L is this:
pi at raspberrypi /etc/sane.d/dll.d $ scanimage -L
device `canon_dr:libusb:001:007' is a CANON DR-7080C scanner
So I think I am using the canon_dr backend but please correct me if i am
wrong or if there is a better way of telling. I am reading the SANE
documentation slowly but its not the easiest of reads!
I shall have a try with the command line using scanimage and see what I can
get. I have yet to put any time in this week as I had a server go pop which
has eaten my lunch times so far.
Also is there a list of valid output formats some where that can be used
with the format option?
Thanks again James
On 19 September 2014 16:24, m. allan noah <kitno455 at gmail.com> wrote:
> James, I think you need to spend some time with scanimage --help at
> the command line, and see what does and doesn't work. You should be
> able to set the source to something like 'ADF Front' and add the -b
> flag to scanimage, and get a batch of sheetfed scans.
> If you don't, then we can try to do some debugging. Also, it is
> helpful if you tell what version of sane-backends you are using.
> On Fri, Sep 19, 2014 at 6:32 AM, James Herrick <wideboy3 at gmail.com> wrote:
> > Hi all,
> > I have a Canon DR-7080C at work that I can no longer use with supported
> > versions of windows because the driver support only goes up to windows
> > vista. So I am giving SANE a try as it seems a shame to can the scanner
> > it is still in very good condition and is a good quality unit.
> > The supported hardware list shows it as untested but someone on this
> > list has had a recent success with a basic test
> > (
> > I am new to using SANE. I'm fairly green in the Linux dept too but I am
> > learning and am an IT Tech by trade from a primarily windows environment
> > I am wondering what is required to get it to a tested working, or not,
> > status and if I can help with the testing at all? I am willing to use a
> > lunch hours and some time after work to help.
> > So far scanimage -L and scanimage -T the same results as the linked email
> > above. Using Xsane I can scan a single page but not if it is placed on
> > document feeder. That doesn't seem to want to feed so far regardless of
> > few settings i have tried. Xsane seems to only be able to do one scan at
> > time before refusing to do the second. I have yet to have a bash at the
> > command line.
> > For my purposes I don't mind if it is only command line compatible as I
> > using a raspberry pi as my header unit for the scanner. This means I can
> > up some hardware buttons to the GPIO pins in a nice case and have some
> > predefined scanning scripts to bring the scanner back to life.
> > Kind regards
> > James
> > --
> > sane-devel mailing list: sane-devel at lists.alioth.debian.org
> > http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel
> > Unsubscribe: Send mail with subject "unsubscribe your_password"
> > to sane-devel-request at lists.alioth.debian.org
> "well, I stand up next to a mountain- and I chop it down with the edge
> of my hand"
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the sane-devel