[sane-devel] Sane Deamon Tutorial

[Martyn Bell]

I am trying to use the SanedeamonTutorial-Community Help Wiki.

I get as far as step 4 Cleanup Tasks (systemd) but then I get this. Failed to execute operation: Invalid argument after sudo systemctl enable saned.socket.

I then carry on & configure the client but when trying to use Simple Scan the scanner scans but with no results followed by Simple Scan is not responding message.

I am using Linux Lubuntu 16.04 on both server & client.

Printer is HP Deskjet 1050-j410 All-in one connected by usb to server.

Printing from client works fine. 

martyn at martyn-M830LU:~$ systemctl status saned.socket
● saned.socket - saned incoming socket
Loaded: loaded (/etc/systemd/system/saned.socket; bad; vendor preset: enabled
Active: active (listening) since Fri 2016-10-21 11:56:15 BST; 1h 42min ago
Listen: [::]:6566 (Stream)
Accepted: 1; Connected: 1

Oct 21 11:56:15 martyn-M830LU systemd[1]: Listening on saned incoming socket.
Oct 21 12:57:14 martyn-M830LU systemd[1]: Listening on saned incoming socket.
Oct 21 13:12:29 martyn-M830LU systemd[1]: saned.socket: Too many incoming connec
Oct 21 13:33:01 martyn-M830LU systemd[1]: saned.socket: Too many incoming connec
Oct 21 13:33:07 martyn-M830LU systemd[1]: saned.socket: Too many incoming connec
lines 1-11/11 (END)


Please help if you can

Regards Martyn Bell