[sane-devel] Using "scanimage" under Gentoo

[Olaf Meeuwissen]

Hi Rainer,

Dr Rainer Woitok writes:

> Olaf,
>
> this is my second try to answer your mail because the first was held due
> to being more than 100 kB in size, and I then cancelled it.
>
> On Wednesday, 2020-02-05 18:47:14 +0900, Olaf Meeuwissen wrote:
>
>> ...
>> So, if HAVE_LIBJPEG is not defined (check include/sane/config.h), that
>> compiled sanei_jpeg.lo is basically empty.
>>
>> Assuming it is not defined ...
>
> It is:
>
>    $ grep -i jpeg include/sane/config.h
>    /* Define to 1 if you have the libjpeg library. */
>    #define HAVE_LIBJPEG 1
>    $
>
>> ...
>>                      Can you re-run `configure` and provide the
>> `config.status` and `config.log` files?
>
> I've appended file "config.status" below.  However, file "config.log" is
> about 300+ kB in size and thus would be quarantained again.  Is it ok to
> mail it only to you privately?

You already did ;-)
By sending mail to me and the list.  Only mail to the list is moderated
so that mail to me went through fine.

Hope this helps,
--
Olaf Meeuwissen, LPIC-2            FSF Associate Member since 2004-01-27
 GnuPG key: F84A2DD9/B3C0 2F47 EA19 64F4 9F13  F43E B8A4 A88A F84A 2DD9
 Support Free Software                        https://my.fsf.org/donate
 Join the Free Software Foundation              https://my.fsf.org/join