[Nut-upsdev] PowerCOM - HID PDC status

[Morozov Alexey]

Dear Arjen,
Thank you for adding sound management command. It very important thing
for end user. I'm not sure that CPU firmware of sample support this
command. Please let me know serial number of BNT-500AP which you have on
hand. We'll check and send updated USB controller chip or whole board
with new CPU version directly from factory.

I look forward to hearing from you.
Sincerely yours
--
Alexey Morozov
distribution manager 


-----Original Message-----
From: Arjen de Korte [mailto:nut+devel at de-korte.org] 
Sent: Tuesday, January 19, 2010 3:29 PM
To: nut-upsdev
Cc: Morozov Alexey; Arnaud Quette
Subject: Re: PowerCOM - HID PDC status

Citeren Alexander Gordeev <lasaine at lvk.cs.msu.su>:

> I've received the units. Are there any special things I should test or

> just the standard NUT setup?

They should be detected out of the box (with the latest version from the
trunk) through the 'usbhid-ups' driver. Note that I just added some
additional commands to enable|disable|mute the beeper of the UPS.  
This is entirely untested, since the model and firmware version I have,
doesn't support this (in fact is quite broken in this respect).  
Please check if this works as intended.

> Maybe we should move back to the dev list?

Yes.

Best regards, Arjen
--
Please keep list traffic on the list