[Nut-upsuser] howto setup BNT-1500AP on gentoo

[Vitaly Oborsky]

Good afternoon. I try to put nut on gentoo. Has executed installation
by a standard command emerge nut. All has passed successfully. I use
UPS POWERCOM BNT-1500AP. It is connected to serial port 1, i.e. for my
system it/dev/tts/0. In/etc/nut/ups.conf
[powercom]
driver = powercom
port = /dev/tts/0
desc = "PowerCom BNT-1500AP on IP-PBX"
modelname = "BNT-1500AP"
linevoltage = 230
type = KIN1500AP

also trying:

[powercom]
driver = powercom
port = /dev/tts/0
desc = "PowerCom BNT-1500AP on IP-PBX"
modelname = "BNT-1500AP"
linevoltage = 230
type = Egys


At start by a command/etc/init.d/upsdrv start gives out the following:

 * Starting UPS drivers ...
Network UPS Tools - UPS driver controller 2.0.4
Network UPS Tools - PowerCom and similars protocol UPS driver $
Revision: 0.5 $ (2.0.4)

data receiving error (-1 instead of 16 bytes)

What correct parameters for BNT-1500AP?