[Nut-upsuser] APC Backups Pro Low Batt
Rabie Van der Merwe
rabievdm at gmail.com
Thu May 11 14:11:10 UTC 2006
It there a way to get the genericups driver to set a output on the serial
On the APC BackupPro the will pull the BattLow line low with a pull down
it's up to you to from the PC side to pull the line high with a pullup
resistor from one of
the RS232 output pins. Then monitor the line with another pin.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Nut-upsuser