[Nut-upsuser] SmartUPS-600 problem with 940-0024C cable

[Christian Ruppert]

Hey guys,

I built my own 940-0024C cable as described here: 
http://www.networkupstools.org/cables/940-0024C.jpg

My problem is that I can't receive anything.
Sending (e.g. through minicom or my own application) works fine.
Nut itself is not able to detect My UPS or anything else.

<snip>
[myups]
	driver = apcsmart
	port = /dev/ttyS0
	cable = 940‐0024C # also tested without cable option
	desc "apc test"
</snip>

# /lib/nut/apcsmart -a myups -D
Network UPS Tools - APC Smart protocol driver 2.00 (2.4.1)
APC command table version 2.0
debug level is '1'
# some delay here..
Unable to detect an APC Smart protocol UPS on port /dev/ttyS0
Check the cabling, port name or model name and try again

So as I said above, sending through My own app or minicom works fine but I'm 
not able to receive anything.
I checked all wires again and again, connections is ok, pins are ok.

Is there anybody who has the same UPS (mine is from 1990) and who is able to 
receive something?


-- 
Regards,
Christian Ruppert
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 198 bytes
Desc: This is a digitally signed message part.
URL: <http://lists.alioth.debian.org/pipermail/nut-upsuser/attachments/20090803/1a7a70b3/attachment-0001.pgp>