[sane-devel] HP ScanJet 4p "no sane devices found"

Peter Kirchgessner peter@kirchgessner.net
Mon, 17 Dec 2001 21:37:07 +0100

Hi Bob,

looks like your SCSI-communication is not ok. The printouts are correct 
in some parts, but contain also some garbage. sane-find-scanner should print

found SCSI processor "HP C1130A 3540" at device /dev/scanner

Can you check if you are using the right cable ?


Bob Soukup wrote:

> I have an HP ScanJet 4p (C1130A) here that I can't get sane to recognize.  I 
> keep getting "no sane devices found".
> cat /proc/scsi/scsi gives:
> Attached devices:
> Host : scsi0 Channel: 00 Id: 02 Lun: 00
>    Vendor: HP         Model: C1  0A         Rev: 35
>    Type:    Processor           Ansi SCSI revision: ffffffff
> Doing "sane-find-scanner" yields:
> found SCSI processor "HPml  us C1li0Aqt  .3  /d 35/h" at device /dev/scanner
> found SCSI processor "HP/l  al C1rc0Ari  ir  sr 35ST" at device /dev/sg0
> found SCSI processor "HPml  us C1li0Aqt  .3  /d 35/h" at device /dev/sga
> Doing SANE_DEBUG_HP reports that dev/scanner does not seem to be an HP 
> scanner.  Also /dev/sg0 and /dev/sga report as not HP scanner.
> Anyone have suggestions as to how to get this puppy to work?
> Thanks
> Bob
> _______________________________________________
> Sane-devel mailing list
> Sane-devel@www.mostang.com
> http://www.mostang.com/mailman/listinfo/sane-devel

Peter Kirchgessner