[sane-devel] HP ScanJet 4p "no sane devices found"
Mon, 17 Dec 2001 16:04:24 -0800
Thanks for the prompt reply, Peter.
At your suggestion I tried another scsi cable but still get the same result.
I don't know if the scanner has or needs a terminator, it worked OK without
one when it was connected to a Macintosh. The scsi adapter is an Advansys
510 ISA. Think I could have a bad scsi card?
On Monday 17 December 2001 12:37, you wrote:
> Hi Bob,
> looks like your SCSI-communication is not ok. The printouts are correct
> in some parts, but contain also some garbage. sane-find-scanner should
> found SCSI processor "HP C1130A 3540" at device /dev/scanner
> Can you check if you are using the right cable ?
> Bob Soukup wrote:
> > I have an HP ScanJet 4p (C1130A) here that I can't get sane to recognize.
> > I keep getting "no sane devices found".
> > cat /proc/scsi/scsi gives:
> > Attached devices:
> > Host : scsi0 Channel: 00 Id: 02 Lun: 00
> > Vendor: HP Model: C1 0A Rev: 35
> > Type: Processor Ansi SCSI revision: ffffffff
> > Doing "sane-find-scanner" yields:
> > found SCSI processor "HPml us C1li0Aqt .3 /d 35/h" at device
> > /dev/scanner found SCSI processor "HP/l al C1rc0Ari ir sr 35ST" at
> > device /dev/sg0 found SCSI processor "HPml us C1li0Aqt .3 /d 35/h" at
> > device /dev/sga
> > Doing SANE_DEBUG_HP reports that dev/scanner does not seem to be an HP
> > scanner. Also /dev/sg0 and /dev/sga report as not HP scanner.
> > Anyone have suggestions as to how to get this puppy to work?
> > Thanks
> > Bob
> > _______________________________________________
> > Sane-devel mailing list
> > Sanefirstname.lastname@example.org
> > http://www.mostang.com/mailman/listinfo/sane-devel