[sane-devel] HP ScanJet 4p (SCSI ncr53c400a) Help !

Carsten Neumann deltor@snafu.de
Mon, 6 May 2002 00:29:06 +0200


On Sun, 05 May 2002, Anastasija wrote:
<snip>
> Trying to load g_NCR5380.o (it was present and installed with the
> system), if I use
>   modprobe g_NCR5380
>   modprobe g_NCR5380 ncr_53400a=1
>   modprobe g_NCR5380 ncr_53400a=1 ncr_addr=0x280
>   modprobe g_NCR5380 ncr_53400a=1 ncr_addr=0x280 ncr_irq=9 
>   modprobe g_NCR5380 ncr_53400a=1 all ncr_irq and ncr_addr couples
> 

There is a junk character between `ncr_53' and `400a'.
That might cause the problem (invalid module parameter)?

> I get the error message:
> 
>   /lib/modules/2.4.18-6mdk/kernel/drivers/scsi/g_NCR5380.o.gz: init_module: No
>   such device
>   Hint: insmod errors can be caused by incorrect module parameters, including
>   invalid IO or IRQ parameters
>   modprobe: insmod /lib/modules/2.418-6mdk/kernel/drivers/scsi/g_NCR5380.o.gz
>   failed
>   modprobe: insmod g_NCR5380 failed
> 
> If I use the following line from README.g_NCR5380
>   modprobe g_NCR5380 ncr_irq=255 ncr_addr=0xc8000 ncr_53c400=1
> or any other with ncr_53c400=1 and non-null adr/irq - the system hangs 
> immediately without any message.
> 

HTH
Kind regards

	Carsten