[sane-devel] HP ScanJet 4p (SCSI ncr53c400a) Help !

Anastasija WhiteUnicorn@mail.ru
Mon, 6 May 2002 13:58:02 +0400

Hello !
On Monday 06 May 2002 02:29
> <snip>
> > Trying to load g_NCR5380.o (it was present and installed with the
> > system), if I use
> >   modprobe g_NCR5380
> >   modprobe g_NCR5380 ncr_53400a=1
> >   modprobe g_NCR5380 ncr_53400a=1 ncr_addr=0x280
> >   modprobe g_NCR5380 ncr_53400a=1 ncr_addr=0x280 ncr_irq=9
> >   modprobe g_NCR5380 ncr_53400a=1 all ncr_irq and ncr_addr couples
> There is a junk character between `ncr_53' and `400a'.

This is just the result of writing my message to the mail-list and speaking 
Russian by icq at the same time. :) Sorry, it should have been ncr_53c400a of 
course. (Cyrillic and Latin "c" are the same key on keyboard)

> That might cause the problem (invalid module parameter)?

No, when I do something in root console, I never switch the keyboard to the 
Cyrillic layout.


Best regards, Anastasija (aka WhiteUnicorn)
Welcome to http://Anastasija.virtualave.net