[sane-devel] Help with Canon 2700f
m. allan noah
anoah at pfeiffer.edu
Wed Aug 2 14:13:36 UTC 2006
quit testing with sane an kooka. until you get it to show up in
sane-find-scanner and scanimage -L, there is no point.
allan
On Wed, 2 Aug 2006, John Bird wrote:
> Hi
> first let me apologise for posting here but I have searched on the net and
> posted in two Linux user groups all to no avail. I'm running Kubutu 6.06 64
> bit using Kernel 26.15.26 and so installed Deb packets from this
> distribution.
> I'm trying (very trying at times) to get GIMP to Scan using a Canon 2700F film
> scanner but neither Gimp nor Kooka see it, They both see the USB flat bed,
> From the Sane document I know that this scanner is supported by sane canon
> backend.This scanner shows in KinfoCenter as Below
>
> Attached devices
> Host scsi0 Channel: 00 Id: 02 Lun: 00
> Vendor: CANON Model IX-27015C Rev: 1.15
> Type: Scanner ANSI SCSI revision: 02
>
> And my SCSI shows up correctly.
> From the documentation in the sane-backends-1.0.16 I found the following which
> seems to applie.
>
> Add the "canon" scanner to the /usr/local/etc/sane.d/dll.conf file:
> -------- cut here ------------
> # enable the next line if you want to allow access through the network:
> #net
> pnm
> #mustek
> #hp
> #qcam
> #umax
> canon
> -------- cut here ------------
>
> Add a "canon.conf" file to the /usr/local/etc/sane.d directory:
> -------- cut here ------------
> scsi CANON
> -------- cut here ------------
>
> In the Kubutu distro I use there is no /usr/local/etc/sane.d/dll, but there is
> a /etc/sane.d/dll which I assume is the equivalent in this distro. In this
> directory I have made a file .conf file, cutting and pasting as instructed.
> There was already a canon conf file in the /etc/sane.d consisting of,
>
> #canon conf
> /dev/scanner
> #/dev/sg0
>
> and so to this I cut and pasted scsi CANON and have tried it in all possible
> combinations commenting out lines and removing comments, but cannot get Gimp
> or Koola to see it even as root. The scanner goes through its calibrate cycle
> on boot up. The only components of SANE I have installed are the following
>
> gimp2.0-quiteinsane
> libsane
> python-imaging-sane
> python2.4-imaging-sane
>
> Any help with this would be most wellcome at this point(please save me from
> the evil empire of windoz)
> John.
>
> --
> sane-devel mailing list: sane-devel at lists.alioth.debian.org
> http://lists.alioth.debian.org/mailman/listinfo/sane-devel
> Unsubscribe: Send mail with subject "unsubscribe your_password"
> to sane-devel-request at lists.alioth.debian.org
>
--
"so don't tell us it can't be done, putting down what you don't know.
money isn't our god, integrity will free our souls" - Max Cavalera
More information about the sane-devel
mailing list