[Nut-upsuser] initial configuration assistance

[George Ross]

> > Network UPS Tools - UPS driver controller 2.0.4
> > Network UPS Tools (version 2.0.4) - APC Smart protocol driver
> >          Driver version 1.99.8, command table version 2.0
> > Unable to detect an APC Smart protocol UPS on port /dev/ttyS0
> > Check the cabling, port name or model name and try again
> > Driver failed to start (exit status=1)

Had you previously connected the UPS by USB?  If so, you'll have to
completely power-cycle it before it'll speak to the serial port again. 
Pull the input power and press-and-hold the off button until the unit gives
a click, and then wait a while...
-- 
Dr George D M Ross, School of Informatics, University of Edinburgh
    Kings Buildings, Mayfield Road, Edinburgh, Scotland, EH9 3JZ
Mail: gdmr at inf.ed.ac.uk   Voice: +44 131 650 5147   Fax: +44 131 667 7209
 PGP: 1024D/AD758CC5  B91E D430 1E0D 5883 EF6A  426C B676 5C2B AD75 8CC5


-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 238 bytes
Desc: not available
Url : http://lists.alioth.debian.org/pipermail/nut-upsuser/attachments/20070131/c07ba9cb/attachment.pgp