[sane-devel] Problem with Sane over network

[Luca Bertoncello]

Am 12.04.2020 um 21:08 schrieb Dr.-Ing. Dieter Jurzitza:

Hi Dieter,

> ok. Ping works - this is an initial step. Look here on my small box:
> 
> 
> fred at scanner:~ $ systemctl status saned.socket
> ● saned.socket - saned incoming socket
>    Loaded: loaded (/lib/systemd/system/saned.socket; enabled; vendor preset: 
> enabled)
>    Active: active (listening) since Sun 2020-04-12 11:07:57 CEST; 9h ago
>    Listen: [::]:6566 (Stream)
>  Accepted: 0; Connected: 0
> 
> does this show the same on your site? 
> 
> On the "main" pc I have only the net backend enabled:
> cat /etc/sane.d/dll.conf | sed '/^#/d'
> net
> 
> can you check this? sane-find-scanner finds nothing. 
> 
> fred at djunix:/etc/sane.d> scanimage -L
> device `net:scanner:hp:libusb:001:002' is a Hewlett-Packard ScanJet 63x0C 
> flatbed scanner
> default device is `net:scanner.karlsruhe.edu:hp:libusb:001:002'

As I wrote yesterday evening, I got the solution.
It was a wrong right in scanbm.socket.

Regards
Luca Bertoncello
(lucabert at lucabert.de)