[sane-devel] Problem with Sane over network

[Dr.-Ing. Dieter Jurzitza]

Hello Luca,
thanks - had seen this. Because I never ever played with scanb and you did not 
mention initially I was focused on sane, only.
Super you found it,
best

Dieter

Am Montag, 13. April 2020, 07:40:18 CEST schrieb Luca Bertoncello:
> Am 12.04.2020 um 21:08 schrieb Dr.-Ing. Dieter Jurzitza:
> 
> Hi Dieter,
> 
> > ok. Ping works - this is an initial step. Look here on my small box:
> > 
> > 
> > fred at scanner:~ $ systemctl status saned.socket
> > ● saned.socket - saned incoming socket
> > 
> >    Loaded: loaded (/lib/systemd/system/saned.socket; enabled; vendor 
preset:
> > enabled)
> > 
> >    Active: active (listening) since Sun 2020-04-12 11:07:57 CEST; 9h ago
> >    Listen: [::]:6566 (Stream)
> >  
> >  Accepted: 0; Connected: 0
> > 
> > does this show the same on your site?
> > 
> > On the "main" pc I have only the net backend enabled:
> > cat /etc/sane.d/dll.conf | sed '/^#/d'
> > net
> > 
> > can you check this? sane-find-scanner finds nothing.
> > 
> > fred at djunix:/etc/sane.d> scanimage -L
> > device `net:scanner:hp:libusb:001:002' is a Hewlett-Packard ScanJet 63x0C
> > flatbed scanner
> > default device is `net:scanner.karlsruhe.edu:hp:libusb:001:002'
> 
> As I wrote yesterday evening, I got the solution.
> It was a wrong right in scanbm.socket.
> 
> Regards
> Luca Bertoncello
> (lucabert at lucabert.de)


-- 
-----------------------------------------------------------
Dr.-Ing. Dieter Jurzitza                    76131 Karlsruhe